Start by cutting the white burlap into approximately 1 1/2 inch wide strips.
Start in the center of the back of the coaster and apply the write burlap with some hot glue. Twist the burlap strips and wrap around in a circle. Apply hot glue as needed to secure.
Continue until entire coaster is covered as shown below.
Cut the burlap into 10 inch by 10 inch squares. I used about 18 squares for my burlap flower wreath.
Secure the coaster in the center of the back of the plate with hot glue.
Gather the burlap squares from one corner to another as shown below.
Twist until both points are in the same direction.
Hot glue the folded squares around the coaster as shown below.
Continue all the way around the coaster as shown below.
Add a second layer of burlap squares around the outer edge of the plate.
Flip over and use a scrap piece of burlap as a hanger.
Add this burlap flower wreath to your front door.