Go Back

DIY Halloween Treats with Your Cricut Machine

Make these candy witch legs with a few supplies and your Cricut.
10 minutes
Total Time 10 minutes
Author Angie Holden

What You Will Need

  • Cricut Cutting Machine
  • Green and black card stock
  • Long skinny colorful candy
  • Glue dots
  • Cricut pen (I used the black fine tip)
  • Witch legs design

Instructions

  • Start by cutting the witch dress and shoes from your card stock using your Cricut.  The design is ready to cut just click "Make It".  You will have to insert a fine tip black pen into the appropriate slot to write the words.  That is right!  The Cricut will write the words and then cut your pieces all with one set up.  Once you have a bunch of pieces cut, break out your glue dots.
  • You will need four glue dots per treat.  Add two at one end of your candy and glue it to the dress as shown below.  Add two more about 1/2 an inch down on the candy to hold it still.  Again secure these to the dress.
  • Then to attach the feet, first use two glue dots to secure the package ends as shown below.
  • Then use two additional glue dots on top of that to add your feet.