Then size the word to fit your wood panel and cut from vinyl.

Weed away all excess vinyl.

Apply the vinyl to the top of your board using transfer tape. With the division between the boards, I applied the top then pressed down into the gap. And finally applied the bottom of the word to the next board. You can watch this in the video above.

Then measure and mark where your mason jars need to be attached.

Drill through the clamp to make a hole large enough for your screw. Use a scrap piece of wood under your clamp when doing this step in order to not damage your work surface.

Then screw through the hole in the clamp and into your board in four areas.

Tighten your screws and add the mason jars.

Then just tighten up the pipe clamp to complete your mason jar wall decor.