This post and photos may contain Amazon or other affiliate links. If you purchase something through any link, I may receive a small commission at no extra charge to you. Any supplies used may be given to me free of charge, however, all projects and opinions are my own.
(Links below are affiliate links which means a portion of your purchase will go to support this site.)
- air dry clay (you could also use the type of clay you bake) — any you have on hand
- Some clay tools or a butter knife
- white paint
- white ribbon
I used air dry clay because I had it on hand. Use whatever type of clay you have. Don’t feel like you need to buy anything special to make these. If you need to buy clay, you do not need much for this project. That hunk pictured above would have made a dozen or more of these feathers. Start by flattening out a piece of clay then cut a feather like shape. Use wax or parchment paper under your project. I am using some plastic clay tools that came with a kit I purchased a few years back. You could use a butter knife instead.
Roughly draw in your feather “stem”. Again use what tools you have on hand. Trim away on one end to make a stem.
Then begin on one side of the stem, using the tool pictured above or something similar, and drag the clay to the edge. I would pull the clay and some would break away. I would just put those pieces in a pile to reuse later. A rough edge is okay. As a matter of fact it is perfect! The rough edge will make your feather look more realistic.
I kept starting in the center and pulling the clay out until I was happy with the shape and appearance of my feather. I then took one of my flat tools and cut the feather away from the parchment paper underneath.
I then used a toothpick to put in the fine details on the feather. The lighter you can go with your toothpick the better. If you use any kind of pressure you will start to remove clay. If that happens, again just remove the material and set aside.
Take a straw and make a hole in the top of your feather for hanging. I then draped my feathers on paint brushes to dry. This gives them more of a three dimensional look.
Let them cure according to the package directions. I then gave mine a coat of white paint on both sides. Please note that my feathers are only finished on one side.